GW Instek PSU-Series Programming User Manual - Manual (Page 82)

PSU Programming Manual
82
Syntax [:SOURce]:RESistance[:LEVel][:IMMediate][:AMPLitude
] {(OHM)|MINimum|MAXimum}
Query Syntax [:SOURce]:RESistance[:LEVel][:IMMediate][:AMPLitude
]?
Parameter Resistance in ohms:
0 ohm ~ Rrated = Vrated/Irated
MIN Minimum internal resistance in ohms
MAX Maximum internal resistance in ohms
Return parameter Returns the internal resistance in ohms.
Example SOUR:RES:LEV:IMM:AMPL 0.1
Sets the internal resistance to 100m
Ω .
[:SOURce]:VOLTage[0]:EXTernal:RANGe
Set
Query
Description Sets or queries the CC or CV control range that is
used during external control. Note: the setting will
only be valid after the power has been cycled.
Syntax [:SOURce] :VOLTage[0]:EXTernal:RANGe {LOW|HIGH}
Query Syntax [:SOURce] :VOLTage[0]:EXTernal:RANGe?
Parameter/Return
parameter LOW A range of 0 V to 5 V is used.
HIGH A range of 0 V to 10 V is used.
Example VOLT:EXT:RANG?
LOW
Returns LOW range.
[:SOURce]:VOLTage[0]:EXTernal:SOURce
Set
Query
Description Sets whether constant current will be controlled
externally or not. Note: the setting will only be
valid after the power has been cycled.
Syntax [:SOURce]:VOLTage[0]:EXTernal:SOURce
{NONE|VOLTage}
Query Syntax [:SOURce]:VOLTage[0]:EXTernal:SOURce?
Parameter/Return
parameter NONE External control is not used.
VOLTage External control is used.