GW Instek PSU-Series Programming User Manual - Manual (Page 124)

PSU Programming Manual
124
A
PPENDIX
PSU Default Settings
The following default settings are the factory configuration settings
for the power supply (Function settings/Test settings).
Initial Settings Default Setting
Output Off
LOCK 0 (Disabled)
Voltage 0V
Current 0A
OVP 1.1 X Vrate
OCP 1.1 X Irate
Normal Function
Settings
Setting Default Setting
Output ON delay time F-01 0.00s
Output OFF delay time F-02 0.00s
V-I mode slew rate select F-03 0 = CV high speed priority
Internal resistance
setting F-08 0.000Ω
Bleeder circuit control F-09 1 = ON
Buzzer ON/OFF control F-10 1 = ON
OCP Delay Time F-12 0.1 (seconds)
Current Setting Limit F-13 0 = OFF
Voltage Setting Limit F-14 0 = OFF
Display Memory
parameter when recalling F-15
0 = OFF
Auto parallel Control F-16 0 = OFF
Measurement Average
Setting F-17
0 = Low
Alarm Recovery and
Output Status F-18
0 = Safe Mode