GW Instek PSU-Series Programming User Manual - Manual (Page 78)

PSU Programming Manual
78
[:SOURce]:CURRent[:LEVel]:TRIGgered
[:AMPLitude]
Set
Query
Description Sets or queries the current level in amps when a
software trigger has been generated.
Syntax [:SOURce]:CURRent[:LEVel]:TRIGgered[:AMPLitude]
{ (A)| MINimum|MAXimum}
Query Syntax [:SOURce]:CURRent[:LEVel]:TRIGgered[:AMPLitude]?
Parameter 0%~105% of the rated current output in amps.
MIN Minimum current level.
MAX Maximum current level.
Return Parameter Returns the current level.
Example SOUR:CURR:LEV:TRIG:AMPL?
38.000
Returns the maximum possible current level in amps.
[:SOURce]:CURRent:LIMit:AUTO
Set
Query
Description Enables or disables the limit on the current setting.
Syntax [:SOURce]:CURRent:LIMit:AUTO {|OFF|ON}
Query Syntax [:SOURce]:CURRent:LIMit:AUTO?
Parameter OFF | 0 Disable the setting current limit
ON | 1 Enable the setting current limit
Return parameter Returns the setting in format.
Example SOUR:CURR:LIM:AUTO 0
Disables the current limit.
[:SOURce]:CURRent:PROTection:DELay
Set
Query
Description Sets the Delay Time for OCP in seconds for turning
the output off. The delay is set to 0.1 by default.
Syntax [:SOURce]:CURRent:PROTection:DELay
{|MINimum|MAXimum}