GW Instek PSU-Series Programming User Manual - Manual (Page 70)

PSU Programming Manual
70
:OUTPut:PON[:STATe]
Set
Query
Description Sets the output state at power-on. This is the
equivalent to the F-92 (Output Status when Power
ON) power on configuration settings. These
settings only apply after the unit has been reset.
Syntax
Return Syntax :OUTPut:PON[:STATe] {|SAFE|FORCe |AUTO}
:OUTPut:PON[:STATe]?
Parameter SAFE | 0 The PSU turns on in the same state the unit
was in prior to the previous shut down. The
output is set to off (default).
FORCe | 1 The PSU turns on in the same state the unit
was in prior to the previous shut down. The
output is set to on.
AUTO | 2 The PSU turns on in the same state the unit
was in prior to the previous shut down, but
with the same output on/off setting.
Return parameter 0 The power on output setting is “SAFE”.
1 The power on output setting is “FORCe”.
2 The power on output setting is “AUTO”.
:OUTPut[:STATe][:IMMediate]
Set
Query
Description Turns the output on or off.
Syntax
Query Syntax :OUTPut[:STATe][:IMMediate] { | OFF | ON }
:OUTPut[:STATe][:IMMediate]?
Parameter OFF | 0 Turns the output off.
ON | 1 Turns the output on.
Return parameter Returns output status of the instrument.