Execution errors – GW Instek PSU-Series Programming User Manual User Manual
Page 119
REMOTE CONTROL
119
Execution Errors
Overview
An
200 ] indicates that an error has been detected
by the instrument’s execution control block.
The occurrence of any error in this class shall
cause the execution error bit (bit 4) in the event
status register (IEEE 488.2, section 11.5.1) to be
set. One of the following events has occurred:
A
header was evaluated by the device as outside
of its legal input range or is otherwise
inconsistent with the device’s capabilities.
A valid program message could not be properly
executed due to some device condition.
Execution errors shall be reported by the device
after rounding and expression evaluation
operations have taken place. Rounding a
numeric data element, for example, shall not be
reported as an execution error. Events that
generate execution errors shall not generate
Command Errors, device-specific errors, or
Query Errors; see the other error definitions in
this section.
Error Code
Description
-200 Execution
error
This is the generic syntax error for devices that
cannot detect more specific errors. This code
indicates only that an Execution Error as
defined in IEEE 488.2, 11.5.1.1.5 has occurred.