Brocade FastIron Ethernet Switch Stacking Configuration Guide - Manual (Page 78)

priority 128
stack-trunk 1/2/1 to 1/2/2
stack-trunk 1/2/6 to 1/2/7
stack-port 1/2/1 1/2/6
stack unit 4
module 1 icx6610-48p-poe-port-management-module
module 2 icx6610-qsfp-10-port-160g-module
module 3 icx6610-8-port-10g-dual-mode-module
priority 100
stack-trunk 4/2/1 to 4/2/2
stack-trunk 4/2/6 to 4/2/7
stack-port 4/2/1 4/2/6
stack unit 5
module 1 icx6610-48-port-management-module
module 2 icx6610-qsfp-10-port-160g-module
module 3 icx6610-8-port-10g-dual-mode-module
priority 128
stack-trunk 5/2/1 to 5/2/2
stack-trunk 5/2/6 to 5/2/7
stack-port 5/2/1 5/2/6
stack enable
Syntax: show running-config
Field descriptions for the show running-config command TABLE 14
Field Description
stack unit # The stack identification number for this unit.
module # Identifies the configuration for modules on this unit.
priority Indicates that a priority has been assigned to this stack unit
stack-trunk Indicates the trunk configuration
Displaying configured stacking ports
The stacking ports may display in the output from the show running-config command in three
different ways.
1. When stacking is enabled, the output shows both stacking ports.
stack unit 1
module 1 fcx-24-port-management-module
module 2 fcx-cx4-2-port-10g-module
module 3 fcx-xfp-1-port-10g-module
stack-port 1/2/1 1/3/1
2. When stacking is not enabled, neither stacking port is displayed.
stack unit 1
module 1 fcx-24-port-management-module
module 2 fcx-cx4-2-port-10g-module
module 3 fcx-xfp-1-port-10g-module
3. If one stacking port is configured, that port will be displayed whether or not stacking is enabled.
stack unit 1
module 1 fcx-24-port-management-module
module 2 fcx-cx4-2-port-10g-module
module 3 fcx-xfp-1-port-10g-module
stack-port 1/3/1
Displaying configured stacking ports
76 FastIron Ethernet Switch Stacking Configuration Guide
53-1003090-02