Brocade FastIron Ethernet Switch Stacking Configuration Guide - Manual (Page 159)

tftp-server
Configures the TFTP server location where Autocopy can download a software image.
Syntax tftp-server ip-address image-location path
no tftp-server ip-address image-location path
Command Default No TFTP server location is configured for Autocopy downloads.
Parameters ip-address
Specifies the IP address of the TFTP server.
image-location path
Specifies directory path to the software image on the TFTP server.
Modes Global configuration mode
Usage Guidelines The no form of this command removes the TFTP server configuration.
To avoid image mismatch issues, set up a TFTP server for Autocopy before configuring a stack.
Examples The following example specifies a TFTP server location where a software image resides:
Brocade(config)# tftp-server 10.1.2.1 image-location /server/builds/
History
Release Command History
08.0.00a This command was introduced.
stack stack-port-resiliency
Error-disables bad ports in a stack
NOTE
This command is only supported on an ICX 6610 device in a stack.
Configures different levels of correctional steps that an active controller can take to fix stacking ports
that cannot send or receive packets though the ports are logically operational. The correctional steps
involve error-disabling malfunctioning ports and/or reloading one or more stack units. The no form of
this command sets the level variable value to 1.
Syntax stack stack-port-resiliency level
no stack stack-port-resiliency level
Command Default This feature is enabled with the level variable value set to 1.
Parameters level
tftp-server
FastIron Ethernet Switch Stacking Configuration Guide 157
53-1003090-02