Brocade FastIron Ethernet Switch Stacking Configuration Guide - Manual (Page 147)

Stacking Commands
● connect..........................................................................................................................145
● multi-peri-port ............................................................................................................... 146
● multi-peri-trunk ............................................................................................................. 146
● multi-stack-port .............................................................................................................147
● multi-stack-trunk ...........................................................................................................148
● peri-port ........................................................................................................................148
● peri-trunk ...................................................................................................................... 149
● show chassis ................................................................................................................150
● show hardware mac-entry ............................................................................................151
● stack suggested-id........................................................................................................ 153
● stack unconfigure.......................................................................................................... 153
● tftp-server...................................................................................................................... 157
● stack stack-port-resiliency.............................................................................................157
connect
Specifies the devices to which a peripheral device connects in a mixed stack.
Syntax connect stack-unit/slotnum/portnum
no connect stack-unit/slotnum/portnum
Parameters stack-unit
Specifies the stack unit ID.
slotnum
Specifies the slot number.
portnum
Specifies the port number in the slot. If the port is part of a trunk, specify only the first port
number (the odd-numbered port) in the trunk.
Modes Stack unit configuration mode
Usage Guidelines The active controller always generates a connect for live peripheral units during stack construction.
This command is optional and can be specified only for peripheral units. You cannot override the
physical connections using the connect command. However, you can use this command on peripheral
devices to make sure that a peripheral device has the unit ID you want in the event of a unit
replacement.
You can use this optional command when configuring a mixed stack with the automatic configuration
method. The no form of this command removes the connection configuration.
FastIron Ethernet Switch Stacking Configuration Guide 145
53-1003090-02