Brocade FastIron Ethernet Switch Stacking Configuration Guide - Manual (Page 150)

Examples The following example changes the trunked link between stack unit 3 (a peripheral device in a mixed
stack) and stack unit 4 (another peripheral device in the mixed stack) to a link between untrunked ports.
Brocade(config-unit-3)# multi-stack-port 3/2/1 and 4/2/1
History
Release Command History
08.0.00a This command was introduced. This command replaces
the
multi-port command.
multi-stack-trunk
Syntax multi-stack-trunk stack-unit/slotnum/portnum to stack-unit/slotnum/portnum and stack-unit/slotnum/
portnum to stack-unit/slotnum/portnum
no multi-stack-trunk stack-unit/slotnum/portnum to stack-unit/slotnum/portnum and stack-unit/
slotnum/portnum to stack-unit/slotnum/portnum
Parameters stack-unit
Specifies the stack unit ID.
slotnum
Specifies the slot number.
portnum
Specifies the port number in the slot.
Modes Stack unit configuration mode
Usage Guidelines Use this command only when the trunked link is live.
Examples The following example changes the untrunked link between stack unit 3 (a peripheral device in a mixed
stack) and stack unit 4 (another peripheral device in the mixed stack) to links between stack trunks. It
creates a stack trunk between ports 1 and 2 on stack unit 3 and between ports 1 and 2 on stack unit 4.
Brocade(config-unit-1)# multi-stack-trunk 3/2/1 to 3/2/2 and 4/2/1 to 4/2/2
History
Release Command History
08.0.00a This command was introduced. This command replaces
the
multi-trunk command.
peri-port
Specifies a port on a backbone device that connects to a peripheral device in a substack.
Syntax peri-port stack-unit/slotnum/portnum
multi-stack-trunk
148 FastIron Ethernet Switch Stacking Configuration Guide
53-1003090-02