Brocade FastIron Ethernet Switch Stacking Configuration Guide - Manual (Page 148)

Examples The following example connects stack unit 3 (a peripheral device) to stack unit 1 (the active controller)
and to stack unit 4 (another peripheral device).
Brocade(config-unit-3)# connect 1/3/1
Brocade(config-unit-3)# connect 4/2/3
History
Release Command History
08.0.00a This command was introduced.
multi-peri-port
Changes both ends of a trunked link between a backbone device and a peripheral device to links
between untrunked ports.
Syntax multi-peri-port stack-unit/slotnum/portnum and stack-unit/slotnum/portnum
no multi-peri-port stack-unit/slotnum/portnum and stack-unit/slotnum/portnum
Parameters stack-unit
Specifies the stack unit ID.
slotnum
Specifies the slot number.
portnum
Specifies the port number in the slot.
Modes Stack unit configuration mode
Usage Guidelines Use this command only when the trunked link is live. The no form of this command removes the port
configuration.
Examples The following example changes the trunked link between stack unit 1 (a backbone device) and stack
unit 3 (a peripheral device) to a link between untrunked ports.
Brocade(config-unit-1)# multi-peri-port 1/3/3 and 3/2/1
History
Release Command History
08.0.00a This command was introduced.
multi-peri-trunk
Changes both ends of an untrunked link between a backbone device and a peripheral device to links
between trunked ports.
Syntax multi-peri-trunk stack-unit/slotnum/portnum to stack-unit/slotnum/portnum and stack-unit/slotnum/
portnum to stack-unit/slotnum/portnum
multi-peri-port
146 FastIron Ethernet Switch Stacking Configuration Guide
53-1003090-02