Brocade FastIron Ethernet Switch Stacking Configuration Guide - Manual (Page 70)

Field descriptions for the show stack command TABLE 9
Field Description
alone: Standalone This device is operating as a standalone device
S: static configuration The configuration for this unit is static (has been saved with a write memory
command).
D: dynamic configuration The configuration for this unit is dynamic and may be overwritten by a new stack unit.
To change to a static configuration, enter the write memory command.
ID The stack identification number for this unit.
Type The model of this unit.
Role The role of this unit within the stack.
MAC address The MAC address of this unit.
Priority The priority assigned to this unit.
State The operational state of this unit.
Comments Additional information about this unit (optional).
NOTE
The active controller removes the dynamic configuration of a unit when the unit leaves. However, if
there is a static trunk configuration associated with the unit, the active controller cannot remove the
dynamic configuration. In this case, you must remove the static trunk and use the no stack unit stack-
unit to manually remove the configuration.
Field descriptions for the show stack detail command TABLE 10
Field Description
Stack Port Status Indicates stacking port status for each stack unit.
Neighbors Identifies stack neighbors (by unit ID) for each stack unit.
ID The stack identification number for this unit.
Stack-port 1 Indicates the port state (up or down) and identifies the port by number (stack-ID/slot/port).
Stack-port 2 Indicates the port state (up or down) and identifies the port by number (stack-ID/slot/port).
Traditional Stacking
68 FastIron Ethernet Switch Stacking Configuration Guide
53-1003090-02