Brocade FastIron Ethernet Switch Stacking Configuration Guide - Manual (Page 11)

About This Guide
● Introduction....................................................................................................................... 9
● What’s new in this document............................................................................................ 9
● Related publications........................................................................................................10
● How command information is presented in this guide.....................................................10
Introduction
This guide includes procedures for configuring the software. The software procedures show how to
perform tasks using the CLI. This guide also describes how to monitor Brocade products using statistics
and summary screens.
Supported hardware
This guide supports the following product families from Brocade:
• FastIron X Series devices (chassis models):
‐ FastIron SX 800
‐ FastIron SX 1600
• Brocade FCX Series (FCX) Stackable Switch
• Brocade ICX ™ 6610 (ICX 6610) Stackable Switch
• Brocade ICX 6430 Series (ICX 6430)
• Brocade ICX 6450 Series (ICX 6450)
• Brocade ICX 6650 Series (ICX 6650)
• Brocade ICX 7750 Series (ICX 7750)
NOTE
The Brocade ICX 6430-C switch supports the same feature set as the Brocade ICX 6430 switch unless
otherwise noted.
NOTE
The Brocade ICX 6450-C12-PD switch supports the same feature set as the Brocade ICX 6450 switch
unless otherwise noted.
For information about the specific models and modules supported in a product family, refer to the
hardware installation guide for that product family.
What’s new in this document
This document includes the information from FastIron software release 08.0.10a.
FastIron Ethernet Switch Stacking Configuration Guide 9
53-1003090-02