Brocade FastIron Ethernet Switch Stacking Configuration Guide - Manual (Page 155)

History
Release Command History
08.0.00a This command was introduced.
stack suggested-id
Specifies the stack unit ID for a standalone device before joining a stack.
Syntax stack suggested-id stack-unit
no stack suggested-id stack-unit
Parameters stack-unit
Specifies the numeric stack unit ID.
Modes Global configuration mode
Usage Guidelines The no form of this command removes the stack unit ID.
The system attempts to assign a bootup ID of a device as its stack unit ID. However, due to timing
issues or the possible unavailability of the bootup ID, a device might not get the stack unit ID that you
want when the stack is formed. The optional stack suggested-id command allows you to specify the
stack unit ID for peripheral devices when you are configuring a traditional or mixed stack using the
manual configuration method.
This command is configured on a standalone device before joining a stack.
Examples The following example sets the stack unit ID on a device to 3.
Brocade(config)# stack suggested-id 3
History
Release Command History
08.0.00a This command was introduced.
stack unconfigure
Returns a stack member to its pre-stacking configuration or state.
Syntax stack unconfigure [ stack-unit | all | me | clean | mixed-stack ]
Parameters stack-unit
Specifies the numerical ID of a stack member. This option is available on the active
controller only.
all
Specifies all stack members. This option is available on the active controller only.
me
stack suggested-id
FastIron Ethernet Switch Stacking Configuration Guide 153
53-1003090-02