Brocade FastIron Ethernet Switch Stacking Configuration Guide - Manual (Page 156)

Specifies the stack member from which the command is executed. This option is available
on all stack members.
clean
Specifies to remove the startup configuration and reboot to a clean unit.
mixed-stack
Specifies to remove all peripheral ports and peripheral trunks from the ICX 6610 devices. It
also specifies to recover ICX 6450 peripheral device configurations from before they were
members of the mixed stack, and reload them. This option is available on the active
controller only in a mixed stack.
Modes Privileged EXEC mode
Usage Guidelines When a stack unit that did not have an original startup configuration file is unconfigured, it becomes a
clean unit. It is possible that this unit could automatically rejoin the stack if its module configuration
matches that of the active controller. To prevent this from happening accidentally, disconnect the unit to
be unconfigured, and then issue the stack unconfigure me command on it.
Examples Traditional stack example
The following example shows a session where stack unit 2 is unconfigured in a traditional stack.
Brocade(config)# show stack
alone: standalone, D: dynamic config, S: static config
ID Typ Role Mac Address Pri State Comment
1 S FCX624 active 0012.f2eb.a900 128 local Ready
2 S FCX648 standby 00f0.424f.4243 0 remote Ready
3 S FCX624 member 00e0.5201.0100 0 remote Ready
Brocade# stack unconfigure 2
Will recover pre-stacking startup config of this unit, and reset it. Are you sure?
(enter 'y' or 'n'): y
Stack 2 deletes stack bootup flash and recover startup-config.txt from .old
Brocade# show stack
alone: standalone, D: dynamic config, S: static config
ID Type Role Mac Address Pri State Comment
1 S FCX624 active 0012.f2eb.a900 128 local Ready
2 S FCX648 member 0000.0000.0000 0 reserved
3 S FCX624 standby 00e0.5201.0100 0 remote Ready
Stacking Commands
154 FastIron Ethernet Switch Stacking Configuration Guide
53-1003090-02