Brocade FastIron Ethernet Switch Stacking Configuration Guide - Manual (Page 158)

3 S ICX6450-24 member 0000.0000.0000 0 reserve
4 S ICX6450-24P member 0000.0000.0000 0 reserve
5 S ICX6450-24P member 0000.0000.0000 0 reserve
6 S ICX6450-48 member 0000.0000.0000 0 reserve
7 S ICX6450-48 member 0000.0000.0000 0 reserve
8 S ICX6450-24P member 0000.0000.0000 0 reserve
active standby
+---+ +---+
=2/6| 1 |2/1==2/6| 2 |2/1=
| +---+ +---+ |
| |
|------------------------|
Use the show stack command to verify that peripheral devices are no longer part of the mixed stack.
The show stack commands are executed on ICX 6450 devices that are no longer part of the mixed
stack.
In the following example, the Role column shows “alone” indicating that it is a standalone device. This
means that the device was a standalone device before joining the mixed stack.
Brocade# show stack
***** Warning! stack is not enabled. *****
alone: standalone, D: dynamic config, S: static config
ID Type Role Mac Address Pri State Comment
1 S ICX6450-24P alone 748e.f8b0.6c00 0 local None:0
+---+
2/1| 1 |2/3
+---+
Current stack management MAC is 748e.f8b0.6c00
Note: no "stack mac" config. My MAC will change after failover.
In the following example, the Role column shows “active,” “standby,” or “member” indicating that it these
devices are part of a stack. This means that the devices were part of a traditional stack before joining
the mixed stack.
Brocade# show stack
alone: standalone, D: dynamic config, S: static config
ID Type Role Mac Address Pri State Comment
1 S ICX6450-24P active 748e.f8b0.6c00 128 local Ready
2 S ICX6450-48 standby 748e.f8d4.2300 0 remote Ready
3 S ICX6450-48 member 748e.f8d4.02c0 0 remote Ready
standby active
+---+ +---+ +---+
2/1| 3 |2/3--2/1| 2 |2/3--2/1| 1 |2/3
+---+ +---+ +---+
Standby u2 - No hitless failover. Reason: hitless-failover not configured
Current stack management MAC is 748e.f8b0.6c00
Note: no "stack mac" config. My MAC will change after failover.
History
Release Command History
07.4.00 This command was introduced.
08.0.00a The mixed-stack option was added. The rollback
option was deprecated.
Stacking Commands
156 FastIron Ethernet Switch Stacking Configuration Guide
53-1003090-02