AMX Modero NXT-1200V User Manual
Nxd/t-1200v
Table of contents
Document Outline
- NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel
- Introduction
- Touch Panel Accessories
- Overview
- NXA-AVB/ETHERNET Breakout Box (FG2254-10)
- Modero Table Top Cable (CA2250-50)
- NXA-CFTP Compact Flash (FG2116-2x)
- NXA-PCI80211G Wireless Card (FG2255-04)
- Installation and Upgrade of the Internal NXT Components
- Installation and Upgrade of the Internal NXD Components
- NXT-BP Power Pack (FG2255-10)
- NXA-BASE/B Battery Base Kit (FG2255K)
- NXT-CHG Battery Charger Kit (FG2255-50K)
- Installation Procedures: NXD-1200V Panels
- Panel Calibration
- Configuring Communication
- Overview
- Modero Setup and System Connection
- Configuring and Using USB with a Virtual Master
- Step 1: Setting up the Panel and PC for USB Communication
- Step 2: Confirming the Installation of the USB Driver on the PC
- Step 3: Confirm and View the current AMX USB device connections
- Step 4: Using a USB to Configure a Virtual Master (using NetLinx Studio)
- Step 5: Confirm and View the current AMX USB device connections
- Wireless Settings Page - Wireless Access Overview
- Configuring a Wireless Connection
- Step 1: Configuring the Panel’s Wireless IP Settings
- Step 2: Configuring the Card’s Wireless Security Settings
- Configuring a Wired Ethernet Connection
- Step 1: Configuring the Panel’s Wired IP Settings
- Step 2: Choosing a Master Connection Mode Setting
- Step 3: Configuring the Ethernet Connection Type
- Using G4 Web Control to Interact with a G4 Panel
- Using your NetLinx Master to control the G4 panel
- Upgrading Modero Firmware
- Firmware Pages and Descriptions
- Programming
- Appendix
- Troubleshooting