AMX Modero NXT-1200V - Manual (Page 28)

Touch Panel Accessories
16 NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel
4. Rotate the panel back over (while gripping the entire unit with outer housing) and rest the base on a flat
surface.
5. Gently tilt the LCD backward to a 45° angle.
6. In a single motion, carefully pull the outer housing up and then out (away from the LCD panel) to expose
the internal circuit board.
7. Unscrew the Stereo Output nut from the Stereo Output jack.
8. Firmly grab the existing connector plate and slide it up and away from the base.
Step 2: Install the 802.11g mini-PCI Wireless Card
1. Discharge any static electricity from your body by touching a grounded metal object.
2. Locate the mini-PCI card connector on the main board (FIG. 18 and FIG. 19).
3. Carefully remove the gold-tipped terminal ends of the antenna from their factory default connectors on
the main board. The antenna is secured at this location to restrict its movement prior to connection to a
wireless card.
4. Firmly grasp the NXA-PCI80211G mini-PCI card (from the edges) and insert the pins (at a 25° angle)
into the opening on the connector (FIG. 20).
FIG. 17 Location of the attachment screws underneath an NXT panel base
FIG. 18 Location of the NXA-PCI80211G wireless card on the NXT board
Unscrew these
eight Housing
Screws to remove
the circuit board
housing
DO NOT
REMOVE
these screws
They secure
the speakers
to the main
board
Base plate
Outer housing
45°
Hinge Brackets (2)
I/O connector
Compact Flash card
Outer Housing
plate
Eight Housing
Screws
NXA-PCI80211G
wireless card
location