AMX Modero NXT-1200V - Manual (Page 25)

Touch Panel Accessories
13 NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel
NXA-CFTP Compact Flash (FG2116-2x)
Every Modero panel is shipped with two factory default modules: an EXM Memory Module and a Compact
Flash card. These panels are shipped with a 256 memory module which is not upgradeable.
The default 128 MB Compact Flash card is factory programmed with specific panel firmware and is the only
upgradeable memory component. This component can be ordered from AMX in several different upgrade
sizes (as listed in the following table):
Upgrading the internal components involves opening the panel enclosure/outer housing to access the internal
circuit board, removing the existing part, and replacing them with the upgrade components, as described in the
following sections.
NXA-PCI80211G Wireless Card (FG2255-04)
The 1200V-Series and VG-Series Modero touch panels can connect to an internal NXA-PCI80211G
compatible mini-PCI Wireless Card connected to two antennas (57-2250-10). All 1200-V and VG-Series
panels come factory installed only with the two antennas used for later connection to the optional wireless card
which is field-installable.
The NXA-PCI80211G card functions using a 2.4GHz bandwidth with a maximum data transfer rate of
54Mbps. This card is compatible with IEEE 802.11 standards such as: 802.11b and 802.11g.
The NXA-80211G allows the end-user to take advantage of larger bandwidth to utilize features such as:
wireless intercom, Motion JPEG, networked video, and standard wireless Ethernet communication to both a
NetLinx controller and networked computers. Please follow your particular Wireless Access Point’s
instruction manual for the correct procedures to setup either a secured or unsecured connection.
Optional Compact Flash Memory Upgrades
Compact Flash:
NXA-CFTP256M - 256 MB Compact Flash card (FG2116-23)
NXA-CFTP512M - 512 MB Compact Flash card (FG2116-24)
NXA-CFTP1G - 1 GB Compact Flash card (FG2116-25)
It is recommended that any upgrade of internal equipment be done simultaneously in
order to reduce the risk of damage to internal components.
FIG. 15 NXA-PCI80211G mini-PCI Wireless Card
FIG. 16
This device complies with Part 15 of the FCC rules. Subject to the following two conditions:
1. This device must not cause harmful interference and
2. This device must accept all interference, including interference that interferes with the
operation of this device.
Modifications not expressly approved by the manufacturer will void the user’s authority
to operate the equipment.
WARNING: This device has been evaluated and found to be compliant with the FCC Rules
for RF Exposure when the device is operated at a minimum separation distance from the
user and nearby persons. Operation of this device at closer distances should be avoided.
FCC Statement:
Certifications: FCCID: CWU-WN2301A, CE, EN 60950, EN 300 328,
and RSS 210