AMX Modero NXT-1200V - Manual (Page 66)

Configuring Communication
54 NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel
1. Verify this direct USB connection (Type-A on the panel to mini-USB on the panel) is configured properly
using the steps outlined in the previous two sections.
2. With the panel already configured for USB communication and the Virtual Master setup within NetLinx
Studio, its now time to verify the panel is ready to receive files.
3. Click the OnLine Tree tab in the Workspace window to view the devices on the Virtual System.
The default System value is one.
4. Right-click on the System entry (A in FIG. 58) and select Refresh System. This causes a refresh of all
project systems, establishes a new connection to the Virtual Master, and populates the System list with
devices on your particular system.
Wireless Settings Page - Wireless Access Overview
IP Routing
The behavior of the wireless routing is largely dependent on the wired network interface. Although the panel
can be connected to two networks simultaneously it may only have one gateway. If the wired network was
successfully set up and a gateway was obtained; then the default route for all network traffic will be via the
wired network. In the event that the wired network was not configured, then the default route for all network
traffic will be via the wireless network. The wired network connection always takes priority.
As an example: Imagine a panel connected to two networks A & B. A is the wired network and B is the
wireless network. If the Master controller is on either of these networks then it will be reached. However if the
Master controller is on a different network, C, then determining which network interface (wired or wireless)
that will be used is dependent on the gateway.
Hot Swapping
Hot swapping is not an issue on these panels as the card is installed within the unit and cannot be removed
without first removing the housing.
In the case of DHCP, there must be a DHCP server accessible before the fields are populated.
A mini-USB connection is only detected after it is installed onto an active panel.
Connection to a previously powered panel which then reboots, allows the PC to
detect the panel and assign an appropriate USB driver.
FIG. 58 Using USB for Virtual Master communication
A
B