AMX Modero NXT-1200V - Manual (Page 43)

Installation Procedures: NXD-1200V Panels
31 NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel
Cable Installation for the MP-TP12 Back Box
1. Connect the cable connectors (RJ-45, Ethernet, and any other audio/video wiring) to their respective
locations along the side of the touch panel.
2. Thread the incoming cables through the strain relief grommet opening on the rear plastic cover (FIG. 34).
Finalizing the installation
1. Gently place the rear plastic cover over the NXD panel (with LCD and MB-TP12 back box).
2. Insert the protruding cables, coming out from the opening on the rear plastic cover, into the open strain
relief grommet.
3. Allow some slack/length on these cables as a service loop. This service loop provides enough cable
length so you can later remove the NXD (with connected cables) from the rear plastic cover.
4. Carefully apply pressure to close the strain relief grommet over the desired cable location.
5. Firmly push the Strain Relief Grommet into the opening (toward the inside) until the rim is securely flush
against the back of the rear plastic cover (FIG. 34).
FIG. 34 Location of the attachment screws on the NXD back box and VESA housing
Four (#8-32) screws
Internal panel casing
MB-TP12 back box
Twelve
Rear plastic cover
Connector
Four (pan-head) Housing Screws
Securing
Strain relief grommet (Clip facing up)
Rim of the strain relief grommet
should lie flush against enclosure
Opening
hole locations
(3 on each side)
securing
DO NOT REMOVE
screws
#6-32
VERIFY THE LENGTH AND LOCATION OF THE INSERTED CABLES. ONCE THE
STRAIN RELIEF GROMMET IS CLOSED, IT IS DIFFICULT TO RE-OPEN.
Verify the Strain Relief Grommet is securely closed over the cables and the clip is
facing the correct direction (upwards). The process of securing the strain relief
grommet may require the use of pliers. Also verify the length and location of the
inserted cables. Once the strain relief grommet is closed, it is difficult to re-open.