AMX Modero NXT-1200V - Manual (Page 16)

Introduction
4 NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel
1200V-Series Modero Connectors
FIG. 2 shows the connectors on the 1200V Modero Video panels. The Audio/Video RJ-45 connector provides
differential audio/video signals between the touch panel and the NXA-AVB/ETHERNET.
This connector routes Composite video, Stereo (left/right) audio, and microphone audio.
Cleaning the Touch Overlay
You should clean the touch screen overlay after each day’s use. Always use clean cotton cloths and a spray
bottle containing water.
Connecting and Using Input Devices
The 1200V panel can have up to two USB-capable input devices connected for use on its different firmware
and TPD4 panel pages. These input devices can consist of a keyboard or mouse.
1. Insert the input device USB connectors into the appropriate USB connector on the panel.
2. Press the on-screen Reboot button from the Protected Setup page to save any changes and restart the
panel.
3. After the panel splash-screen disappears:
 If a USB mouse has been connected, a mouse cursor appears on the panel screen and its location
corresponds to the mouse cursor position sent by the external USB mouse.
 If a USB keyboard has been connected, only on-screen keyboards and keypads will reflect any
external keystrokes sent from the external USB keyboard.
FIG. 2 Connector layout on sample 1200V Video Touch Panels
ETHERNET AUDIO/VIDEO
A
PWR
12VDC
L
PROGRAM
Audio-Video from
NXT-1200V - connectors located
on rear panel of the base NXD-1200V - connectors located
on left side panel
NXA-AVB/ETHERNET
(CAT5)
Stereo
Ethernet
Power
Keyboard/Mouse
USB connectors (2) Mini-USB
(Program Port)
(CAT5)
Output
USB-connected input devices are not detected and recognized by the panel until
power is cycled to the unit.
A mini-USB connection is only detected after it is installed onto an active
panel. Connection to a previously powered panel, allows the PC to detect the
panel and assign an appropriate USB driver.