AMX Modero NXT-1200V - Manual (Page 119)

Firmware Pages and Descriptions
107 NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel
System Settings Page
The System Settings page (FIG. 102) sets the Secondary DNS Address information with its corresponding IP
communication parameters, NetLinx Master communication settings, and reads the device number assigned to
the Modero panel.
The elements of the System Settings page are described in the table below:
Wireless Settings Page Elements (Cont.)
Wireless Settings (Cont.):
Data Rate The data rate (in Mbps) at which the panel is currently communicating with a
target WAP at (dynamic).
• As you move closer to the target WAP (and both the signal strength/
quality), the data rate increases and as the quality degrades this rate
decreases.
• Data rates for 802.11g communication are: 1, 2, 5.5, 11, and 54 Mbps.
• Ex: 802.11g has a max data rate is 54 Mbps.
FIG. 102 System Settings page showing default values (reads and assigns values to the panel and Master)
System Settings Page Elements
Back: Saves the changes and returns you to the previously active touch panel page.
Connection Status icon: This visual display of the connection status allows the user to have a current
visual update of the panel’s connection status regardless of what page is
currently active.
• A Lock only appears on the icon if the panel has established a connection
with a currently secured target Master (requiring a username and password).
IP Settings: Sets the IP communication values for the panel and contains:
DHCP/Static Sets the panel to either DHCP or Static communication modes.
• DHCP (Dynamic Host Configuration Protocol) assigns IP Addresses from
client stations logging onto a TCP/IP network via a DHCP server.
• Static IP is a permanent IP Address that is assigned to a node in a TCP/IP
network.
IP Address Sets the secondary IP Address assigned to the panel.
Subnet Mask Sets a subnetwork address to the panel.
• Subnetwork mask is the technique used by the IP protocol to filter messages
into a particular network segment (Subnet).
Gateway Sets a gateway value to the panel.
• Gateway is a computer that either performs protocol conversion between
different types of networks/applications or acts as a go-between two or more
networks that use the same protocols.
Host Name Sets the host name of the panel.
IP Settings section
Master Connection section
(NetLinx Master properties)
Master Connection features are not
saved until the panel is rebooted
Red fields are user-editable
Blue fields cycle through choices
Grey fields are read-only