AMX Modero NXT-1200V - Manual (Page 161)

Programming
149 NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel
Input Commands (Cont.)
^SLT
Send a command
to a given slot.
These commands are directed at the video card subsystems. Slot commands contain a
series of name/value pairs separated by commas. These commands are case insensitive.
Syntax:
"’^SLT-,’"
Variables:
slot number = 1 - 3 (each of these options corresponds to an on-board slot
position where the related components reside.)
Slot 1= Composite Video (common to both 1200-V and VG-Series)
Slot 2 = RGB Component Video (only available on the VG-Series)
Slot 3 = Streaming MPEG Video (only available on the VG-Series)
slot command = see list below:
Interlace = <0 or 1> where:
0 = Deselects Interlace and 1 = Selects Interlace
Sharpness = < 0 or 1> where:
0 = Disables Sharpness and 1 = Enables Sharpness
SyncOn Green = < 0 or 1> where
0 = Disables SyncOnGreen and 1= Enables SyncOnGreen
Example:
SEND_COMMAND TP,"’^SLT-1,Interlace=1’"
Enables Interlace on the incoming Composite video signal.
SEND_COMMAND TP,"’^SLT-3,Sharpness=1’"
Enables sharpness on the incoming MPEG video stream (if available).
SEND_COMMAND TP,"’^SLT-2,SyncOnGreen=1’"
Enables the SynOnGreen feature for the incoming RGB signal (if available).
^VKS
Send one or more
virtual keystrokes
to the G4
application.
Key presses and key releases are not distinguished except in the case of CTRL, ALT, and
SHIFT.
Refer to the Embedded Codes table on page 150 that define special characters which
can be included with the string but may not be represented by the ASCII character set.
Syntax:
"'^VKS-'"
Variable:
string = Only 1 string per command/only one stroke per command.
Example:
SEND COMMAND Panel,"'^VKS-'8"
Sends out the keystroke 'backspace' to the G4 application.