Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 95)

Getting Started Manual
922138-00 Rev A 87
B
Touch Utilities  Utilities Setup… from the menu bar.
Touch the Remote tab.
Make a Port selection: TCPIP (transmission control protocol/Internet protocol)
or GPIB (general purpose interface bus). If you do not have a GPIB card
installed, the GPIB selection is not accessible.
If you are using GPIB, set a GPIB address by touching inside the GPIB Address
field and entering an address.
Touch the Net Connections button. The Windows Network Connections
screen is shown.
Touch Create a new connection and use the Windows Network Connection
Wizard to make a new connection. Or, touch Local Area Connection to
reconfigure the oscilloscope's connection (if it is already connected to the
network).
Configuring the Remote Control Assistant Event Log
Touch Utilities  Utilities Setup… from the menu bar.
Touch the Remote tab.
Touch inside the Log Mode field and select Off, Errors Only, or Full Dialog
from the pop-up menu.
Export the contents of the event log to an ASCII text file by touching the Show
Remote Control Log button. The Event Logs popup window is shown. Touch
inside the DestFilename field and provide a file name. Now, touch the Export
to Text File button.