Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 25)

Getting Started Manual
922138-00 Rev A 17
B

P
OSITION
- Adjusts the vertical position of the selected zoom trace on
the display. Unlike Offset, the position is not calibrated to the 0 V
reference.

Z
OOM
- Adjusts the vertical zoom (magnification factor) of the selected
zoom trace on the display.

I
NDICATOR
L
AMPS
- The three lamps at the bottom of the panel are lit
according to the kind of trace you are zooming, or whose position you are
adjusting: channel trace, math trace, or memory trace. The exact trace
that is active has a solidly colored descriptor label.
Special Features Controls

I
NTENSITY
- This knob adjusts the intensity of your trace.
Pushing the button toggles between WaveStream fast-
viewing mode and real-time mode.

W
AVE
S
TREAM
L
AMP
- This lamp lights when the
oscilloscope is displaying in WaveStream fast-viewing
mode.

C URSOR T YPE - This push button turns on the cursors,
then cycles through the four different cursor types with
each additional push:

A
DJUST
F
INE
- This dual-function knob controls the
placement of the top or left cursor. When the knob is
in Cursor mode, the CURS lamp is lit.
When you click in any data entry field in any dialog, the
knob automatically switches from cursor placement mode
to adjustment mode, and the ADJ lamp lights. This allows you to dial in
fine-grained values. When you close the dialog, the knob reverts to cursor
placement mode.