Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 90)

WaveRunner Xi-A and MXi-A Oscilloscopes
82 922138-00 Rev A
Comparing Dual Parameters
Set up Dual Parameters by following the previous steps in the
Comparing a Single Parameter topic, except you selecting the Dual
Param Compare condition.
Setting Up Mask Testing
Touch Analysis  Pass/Fail Setup… from the menu bar.
Touch a Q tab. A setup dialog for the position is shown.
Touch inside the Source1 field and select a source from the pop-up menu.
Touch inside the Condition field in the main dialog and select Mask Test.