Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 43)

Getting Started Manual
922138-00 Rev A 35
B
Triggering
Simple Triggers
Edge Trigger on Simple Signals
The instrument uses many waveform capture techniques that trigger on
features and conditions that you define. These triggers fall into two major
categories:

Standard Triggers - activated by basic waveform features or conditions
such as a positive or negative slope, and hold-off

SMART Triggers - sophisticated triggers that enable you to use basic or
complex conditions for triggering.
Use Edge Triggers for simple signals, and the SMART Triggers for signals with
rare features, like glitches.
Controlling Edge Triggering
Horizontal:
Turn the Delay knob in the HORIZONTAL control
group to adjust the trigger's horizontal position.
Or, touch inside the Delay field in the timebase
setup dialog and enter a value, using the pop-up
keypad.
The trigger location is shown by a marker below
the grid
Post-trigger delay is indicated by a left-pointing
arrow below-left of the grid.
The time value is given in the title line of the
TimeBase label below-right of the grid.