Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 101)

Getting Started Manual
922138-00 Rev A 93
B
Touch-Screen Calibration
Touching the Touch-Screen Calibration button starts
the calibration procedure. During the procedure you
are prompted to touch the center of a small cross in
5 key locations on the touch screen. Because
sufficient accuracy cannot be achieved using your
finger, use a stylus instead for this procedure. The
calibration has a ten-second timeout in case no cross
is touched.
Avoid parallax errors by placing your line of sight
directly in front of each cross before touching.
Built-in Stylus Holder
Your WaveRunner Xi-A is supplied with a touch screen stylus. Use the stylus
for more precise touch screen operation. There is also a built-in stylus holder
at lower-right of the front panel.
Preferences
Audible Feedback
You can elect to have audible confirmation each time you touch a screen or
front panel control.
Touch Utilities  Preferences from the menu bar.
Touch the Audible Feedback Enable checkbox so that the oscilloscope emits a
beep with each touch of the screen or front panel control.