Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 75)

Getting Started Manual
922138-00 Rev A 67
B
Touch inside the Source field and select a source
from the pop-up menu. The source can be any trace.
For example, a channel (C1C4), math function (F1F4),
or a waveform stored in non-volatile RAM (M1M4).
Touch inside the Trace Title field if you want to
change the default name of your waveforms. Use the
pop-up keyboard to type in the new name.
NOTE: You can change the name but not the
sequence number.
CAUTION. If you use a name that ends in a number instead of a letter,
the instrument may truncate the number. This is because, by design,
the first waveform is automatically numbered 0, the second 1, etc. For
example, if you want to use waveform name XYZ32 but it is not preceded by
waveforms XYZ0 through XYZ31, the waveform is renumbered with the next
available number in the sequence.
If you need to use a number in your waveform's name, it is recommended that
you append an alpha character at the end of the number: XYZ32a, for
example.
If you are saving to file, touch the Data Format field
and select a format type from the pop-up menu.
If you select ASCII or Excel, also touch the
SubFormat field and select either Time Data or Time
& Ampl. Then touch the Delimiter field and select a
delimiter character from the pop-up menu: comma,
space, semicolon, or tab.
Touch the Browse button for the Save file in
directory field and browse to the location where you
want the file saved.
The file name is assigned automatically and is shown
below the field.
Touch Save Now.