Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 17)

Getting Started Manual
922138-00 Rev A 9
B
Software
The oscilloscope’s hardware and software configuration can be seen as
follows:
In the menu bar, touch Utilities.
In the dialog area, touch Status.
Adding a New Option
New software options can be added after purchasing a code and then enabling
the option on the instrument. Call Teledyne LeCroy Customer Support to place
an order and receive the code.
Monitor Hookup
Connect the external monitor to the VGA port on the side of the instrument
(4).
Plug in the monitor's power cord, and turn on the monitor.
Video Setup
After the system boots, configure the monitors as follows:
NOTE: A mouse is required for dual monitor use.
Minimize the oscilloscope UI by selecting File 
Minimize.