Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 55)

Getting Started Manual
922138-00 Rev A 47
B
Touch one of the Horizontal or Vertical mode
buttons: Relative or Absolute.
If you chose a Relative mode, also touch a readout
parameter button: Y position, delta Y, Y position
plus delta, or slope.
If you chose a Relative mode, touch inside the
Position 1 and Position 2 fields and type in a value
for each cursor. You can also use the Cursors
knobs on the front panel to place the cursors. If
you chose an Absolute mode, do the same for
your single cursor.
If you chose a Relative mode and you would like
both cursors to move in unison as you adjust the
position, touch the Track check box to enable
tracking.
Push the front panel Cursor Type button to
quickly change the type of cursors in use.