Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 24)

WaveRunner Xi-A and MXi-A Oscilloscopes
16 922138-00 Rev A
Horizontal Controls

D
ELAY
-
Horizontally positions the oscilloscope trace on the
display so you can observe the signal prior to the trigger time.
Push the button to reset the delay to zero. A second push
returns the delay to the previous setting. Delay adjusts the
pre- and post-trigger time.

T
IME
/D
IVISION
- Sets the time/division of the oscilloscope
timebase (acquisition system).
Vertical Controls

O
FFSET
- Adjusts the vertical offset of a channel.

V
OLTS
/D
IV
- Adjusts the Volts/Division setting (vertical
gain) of the channel selected.

C
HANNEL
B
UTTONS
- If the channel is already ON, the
channel button makes the channel active. If the
channel is OFF, the channel button turns the channel
ON. When the channel is active, the channel button
is lit, and the Offset and Volts/Div knobs are
dedicated to that channel.
Zoom Control Knobs

Q
UICK
Z
OOM
- Automatically displays magnified
views of up to four signal inputs on multiple grids.
With four input signals, the signals are displayed
along with four zoom traces, each on its own grid.
This button turns off all other traces and redefines all
math functions to be zooms of channels.

P OSITION
- Adjusts the horizontal position of a
zoom trace on the display. The zoom region is
highlighted in color on the source trace. Unlike Delay, the position is not
calibrated to the trigger position.

Z OOM
- Adjusts the horizontal zoom (magnification factor) of the
selected zoom trace.