Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 102)

WaveRunner Xi-A and MXi-A Oscilloscopes
94 922138-00 Rev A
Auto-calibration
You can choose to have your instrument automatically recalibrate itself
whenever there is a significant change in ambient temperature. If you do not
enable this option, the oscilloscope only recalibrates at startup and whenever
changes are made to certain operating conditions.
Touch Utilities  Preferences from the menu bar.
Touch the Automatic Calibration Enable checkbox.
Language Selection
You can choose to display screen control names in a language other than
English by touching inside the Language field and making a selection from the
pop-up menu. This change takes effect immediately with requiring a reboot of
the oscilloscope.
Performance Optimization
You can set up the oscilloscope to optimize either calculating speed or display
speed. If the display update rate is of primary concern to you, optimize for
Display. If acquisition and analysis are more important, optimize for analysis.
Optimizing for analysis can be useful when persistence or averaging is used,
giving higher priority to waveform acquisition at the expense of display update
rate.
The choices are presented as a spectrum with highest values at the extremes:
Touch Utilities  Preferences from the menu bar.
Touch one of the optimization icons.