Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 86)

WaveRunner Xi-A and MXi-A Oscilloscopes
78 922138-00 Rev A
Depending on your oscilloscope model, you can configure up to 8 pass/fail
conditions. The Boolean conditions to determine if your waveform passes are
as follows:
All True All False
Any True Any False
All Q1 to Q4 Or All Q5 to Q8 Any Q1 to Q4 And Any Q5 to Q8
Setting Up Pass/Fail Testing
Initial Setup
Touch Analysis  Pass/Fail Setup from the menu bar.
Touch the Actions tab.
Touch the Enable Actions checkbox. This causes the actions you select to
occur depending on your waveform's passing or failing a test.