Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 71)

Getting Started Manual
922138-00 Rev A 63
B
Zooming by Touch-and-Drag
Touch and drag a rectangle around any part of an
input channel waveform, math trace, or memory
trace, or any combination of these. If all traces are
channel traces, zooms designated Z1 to Z4 appear in a
separate grid automatically.
If the traces are non-channel, or a combination of
channel traces and math or memory traces, a
Rectangle Zoom Wizard appears. Select the traces to
be zoomed on the pop-up.
Channel zooms are shown on a separate grid. The
zoom of the math or memory trace appears on the
same grid as the source trace.
Turn the front panel zoom Position knobs to adjust
the vertical and horizontal position of the zoom.
Turn the front panel Zoom knobs to control the
vertical and horizontal magnification factor of the
zoom.
Turn Off Zoom
Touch the trace label for the zoom you want to turn off.
Touch the Trace On checkbox to delete the check mark and disable the zoom
trace.