Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 61)

Getting Started Manual
922138-00 Rev A 53
B
Histograms
Creating and Viewing a Histogram
NOTE: The number of sweeps comprising a histogram is displayed in the
bottom line of the trace descriptor label.
Single Parameter Histogram Setup
From Measure Dialog
1. Touch Measure  Measure Setup from the menu bar.
2. Touch the My Measure button.
3. Touch one of tabs P1 through Px.
4. Touch inside the Source1 field and select an input waveform from the
pop-up menu.
5. Touch inside the Measure field and select a parameter from the pop-
up menu.
6. Touch the Histogram button at the bottom of the dialog.
7. Select a math trace in which to place the resulting histogram, and then
close the pop-up menu.