Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 56)

WaveRunner Xi-A and MXi-A Oscilloscopes
48 922138-00 Rev A
Parameter Measurements
Waveform analysis typically begins with the measurement of parameters.
Parameter measurement tools determine a wide range of waveform
properties. Use them to automatically calculate many attributes of your
waveform, like rise time, rms voltage, and peak-to-peak voltage, for example.
There are parameter modes for the amplitude and time domains, custom
parameter groups, and parameters for pass and fail testing. You can make
common measurements on one or more waveforms.
Measure Modes
The selections for Measure Mode allow you to quickly apply parameters for
standard vertical and standard horizontal setups, and custom setups.
Pass and fail parameters can be customized, too. You can accumulate and
display statistics on each parameter's average, lowest, highest, and standard
deviation.
Standard Vertical Parameters
These are the default Standard Vertical Parameters:
mean Mean
sdev Standard deviation
max Maximum
min. Minimum
ampl Amplitude
pkpk Peak-to-peak
Standard Horizontal Parameters
These are the default Standard Horizontal Parameters:
freq Frequency
period Period
width Width
rise Risetime
fall Fall time
duty duty cycle