Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 10)

WaveRunner Xi-A and MXi-A Oscilloscopes
2 922138-00 Rev A
Precautions

Use proper power cord . Use only the power cord shipped with this
instrument and certified for the country of use.

Maintain ground . This product is grounded through the power cord
grounding conductor. To avoid electric shock, connect only to a
grounded mating outlet.

Connect and disconnect properly . Do not connect/disconnect probes or
test leads while they are connected to a voltage source.

Observe all terminal ratings . Do not apply a voltage to any input (C1, C2,
C3, C4 or EXT) that exceeds the maximum rating of that input. Refer to
the front of the oscilloscope for maximum input ratings.

Use only within operational environment listed . Do not use in wet or
explosive atmospheres.

Use indoors only .

Keep product surfaces clean and dry .

Do not block the cooling vents . Leave a minimum six-inch (15 cm) gap
between the instrument and the nearest object. Keep the underside
clear of papers and other objects.

Do not remove the covers or inside parts . Refer all maintenance to
qualified service personnel.

Do not operate with suspected failures . Do not use the product if any part
is damaged. Obviously incorrect measurement behaviors (such as
failure to calibrate) might indicate impairment due to hazardous live
electrical quantities. Cease operation immediately and sequester the
instrument from inadvertent use.