Teledyne LeCroy WaveRunner МXi-A Getting Started Manual - Manual (Page 64)

WaveRunner Xi-A and MXi-A Oscilloscopes
56 922138-00 Rev A
9. Under Scaling, touch inside the #Bins field and enter a value from 20
to 2000.
10. Touch the Find Center and Width button to center the histogram.
Or touch inside the Center, then the Width, fields and enter a value
using the pop-up numeric keypad.
11. Touch inside the Vertical Scale field and select Linear or Linear
Constant Max from the pop-up menu:

A linear histogram continues growing as values accumulate.

A linear-constant-maximum histogram continually rescales itself
and remains well within the grid.
Viewing Thumbnail Histograms
Histicons are miniature histograms of parameter
measurements that appear below the grid. These thumbnail
histograms let you see at a glance the statistical distribution of each
parameter.
Touch Measure  then one of the Measure Mode buttons: Std Vertical, Std
Horizontal, or My Measure from the menu bar.
Touch the Histicons checkbox to display thumbnail histograms below the
selected parameters.
NOTE: For measurements set up in My Measure, you can quickly display an
enlarged histogram of a thumbnail histogram by touching the Histicon you
want to enlarge. The enlarged histogram is shown superimposed on the trace
it describes. This does not apply to Std Vertical or Std Horizontal
measurements.