IAI America SSPDACR - Manual (Page 80)

13. Replacement/Adjustment Procedure for Stainless Sheet
72
(8) After checking the tension of the stainless sheet and confirming absence of slacking, position deviation or
other problems, tighten the two screws alternately. At the end, tighten them to a uniform torque to secure the
stainless sheet. If the two screws are tightened non-uniformly, the sheet may meander or lift. If the tension
still presents a problem, repeat the adjustment from step (5).
(9) Install the slider cover using the four screws.
(10) Once the slider cover has been installed, move the slider to confirm absence of abnormal noise. If rubbing
noise, etc., is heard, the stainless sheet may not be adjusted properly. Remove the slider cover and repeat
the adjustment from step (5).
Firmly tighten the screws on both sides to prevent the stainless sheet from moving.
Tightening torque: 191 Nxcm (19.5 kgfxcm)