IAI America SSPDACR - Manual (Page 77)

13. Replacement/Adjustment Procedure for Stainless Sheet
69
13. Replacement/Adjustment Procedure for Stainless Sheet
The following explains how to replace and adjust the stainless sheet.
The screws and other parts that are removed to take out the old stainless sheet will be needed when the
components are assembled again after to install the new sheet. To prevent missing parts, prepare a storage box,
etc., and keep them in the box, etc.
13.1 Preparation
(1) “What you need for replacement”
x New stainless sheet
x Allen wrench set
x Scale
(2) “Notes on tension of the stainless sheet”
Deterioration/wear of the stainless sheet is affected by the tension.
If the stainless sheet is tensioned with a strong force and there is an excessive clearance from the slider cover,
the stainless sheet may undergo fatigue fracture.
On the other hand, too small a tension may cause the stainless sheet to slack and contact the back of the
slider cover, consequently raising dust.
Accordingly, use a dedicated adjustment jig to adjust the tension of the stainless sheet until the clearance from
the back of the slider cover corresponds to the specified dimension.
(3) Name of each part
Stainless sheet
retainer plate
Stainless
sheet
Slider cover
Stainless sheet
retainer plate
Screws for affixing
slider cover