Fairbanks FB2550 SERIES - Manual (Page 170)

Section 9 Network Application Configuration
07/2012 170 51254 Rev. 3
E. STATUS/COMMAND WORD BIT USAGE, CONTINUED
SCALE ID WORD 0 BITS 0,1,2
Command: Changes Instrument display to applicable scale.
Status: Value is the scale id if the scale is selected, from instrument
keyboard or fieldbus, else the value is zero.
MOTION WORD 0 BIT 3
Command: Not applicable.
Status: Indicates that the scale senses motion.
OVER CAPACITY WORD 0 BIT 4
Command: Not applicable.
Status: Indicates that the scale is at 105% of capacity. If this condition is true
the gross weight is sent to the fieldbus as the scale capacity.
WITHIN 2% CAPACITY WORD 0 BIT 5
Command: Not applicable.
Status: Scale is within a range of +/- 2% of capacity and zero.
ENABLE TARE WORD 0 BIT 6
Command: Enable keyboard tare or auto tare weight.
Status: Tare weight enabled.
DISABLE TARE WORD 0 BIT 7
Command: Disable keyboard tare and auto tare weight.
Status: Tare weight disabled.
LB WEIGHT UNITS WORD 0 BIT 8
Command: Switch scale to lb units.
Status: Scale is indicating in lb units.