beautypg.com

Resetting to the axis factory defaults – Fairbanks FB2550 SERIES User Manual

Page 135

background image

Section 7: Video Camera Programming

07/2012

135

51254 Rev. 3

7.2.3. RESETTING TO THE AXIS FACTORY DEFAULTS

Restoring the Factory Default Settings is used when the previous steps do not
resolve problems with the Camera Unit.

1. Disconnect the

POWER

CABLE

from the Camera

unit.

2. Remove the two (2) Torx

screws, holding the camera
into place with a

T20

ALLEN KEY

.

3. Flip the camera over to reveal

the control components on the
bottom.

4. Reconnect the

POWER CABLE

.

– Wait approximately fifteen (15) seconds until the

NET

and

PWR

led lights

are orange.

5. Press and hold the

RESET

button for approximately thirty (30) seconds

until the

NET

led light flickers green, then release

RESET

button.

– Doing this resets the Factory Defaults.

6. Reassemble the Camera Unit and follow

STEPS 1-16

from SECTION

11.2. and 11.2.1. to complete the programming process.

TORX Screws

RESET NET PWR
SWITCH LED LED