Fairbanks FB2550 SERIES - Manual (Page 103)

Section 5: Input/ Output
07/2012 103 51254 Rev. 3
5.8.4. METHOD 2 - CUSTOMIZING DATA STRINGS,
CONTINUED
22. Select the PRIMARY UNITS: data
entry block which is located to the
right of the legend.
23. Enter the primary units legend as
shown in the image to the right.
Example: lb
24. Select the SECONDARY UNITS:
data entry block which is located to
the right of the legend.
25. Enter the secondary units legend, as
shown in the image to the right.
Example: kg
26. Press the SAVE CHANGES button
when any changes are made
otherwise the changes will be lost.
27. Press PAGE FORWARD once.
– This page configures the Status: token
for the output data string.
– Each item configured will indicate the
character programmed in the output data
string.
– If Motion: is present on the scale, a “M”
will be transmitted in the data string. The
Capacity: value will indicate if the scale
is overloaded.
28. Press the SAVE CHANGES button when any changes are made otherwise
the changes will be lost.