1 khz (milliohm) various components – Atec Agilent-16047A User Manual
Page 85
16338A Test Lead Kit
Terminal Connector: 4-Terminal, BNC
DUT Connection: 4-Terminal
80
1 kHz (Milliohm)
Various Components
Description: The 16338A contains four types of test
leads and a mating cable, which are designed to operate
with the 4338B. These test leads can be mixed or
matched depending on the type of sample being mea-
sured. The test leads and mating cable are shown in the
figure below:
Applicable Instruments: 4338B, (4338A)*
* denotes the instrument is obsolete.
Frequency: 1 kHz
Operating Temperature: 0°C to 55°C
Furnished Accessories:
Compensation and Measurement: Short compensation
is recommended before measurement. When using the
16005B or the 16005C/D, first connect the voltage termi-
nals together and the current terminals together. Then,
connect the two pairs of voltage and current terminals
together. When using the 16006A, firmly press the probes
against a shorting plate. Make sure that all four elec-
trodes of the probes contact via the shorting plate and are
placed closely to each other. The shorting plate should
have very low residual impedance, so a high conductive
metal plate should be used. When using 16007A/B, hold a
shorting plate with the alligator clips. Make sure that the
voltage leads (or black leads) are next to each other.
Available test leads
Description
P/N
Qty.
Kelvin Clip Leads (large)
16005B
2
Kelvin Clip Leads (small, red)
16005C
1
Kelvin Clip Leads (small, black)
16005D
1
Pin-Type Probe Leads
16006A
2
Alligator Clip Lead (red)
16007A
1
Alligator Clip Lead (black)
16007B
1
Mating Cable
16143B
1
Carrying Case
16338-60001
1
Operation and Service Manual
16338-90000
1
16143B
Mating Cable
16005B
Keivin Clip Leads
(large clip)
16005C/D
Kelvin Clip Leads
(IC clip)
16006A
Pin-type Probe
Leads
16007A/B
Alligator Clip
Leads
Connect:
16005B
16005C/D
16006A
16007A/B