Atec Agilent-16047A - Manual (Page 29)

24
Up to 110 MHz (4-Terminal Pair) Other Components
16089C Kelvin IC Clip Leads
Terminal Connector: 4-Terminal Pair, BNC
DUT Connection: 4-Terminal
Cable Length (approx.):
1.3m (from connector to clip's tip)
Weight (approx.): 300 g
Additional Error: The additional error is
negligible when compared to the instrument's
accuracy.
Description: This test fixture makes it possible to
measure odd-shaped components that cannot be
measured with conventional fixtures. It is equipped with
two insulated Kelvin clips.
Applicable Instruments: 4263B, 4268A, 4279A, 4284A,
4285A, 4288A, 4294A, (4192A, 4194A, 4263A, 4278A)*
* denotes the instrument is obsolete.
Frequency: 5 Hz to 100 kHz
Maximum Voltage: ±42 V peak max (AC+DC)
Operating Temperature: 0°C to 55°C
DUT Size:
See figure below
Furnished Accessories:
Compensation and Measurement: Open and short
compensations are recommended before measurement.
For open compensation, do not connect the Kelvin clips to
anything. Short compensation is performed by connecting
the Kelvin clips together. After performing open and short
compensations, the DUT is held with the Kelvin clips.
16089D Kelvin Alligator Clip
Leads
Terminal Connector: 4-Terminal Pair, BNC
DUT Connection: 4-Terminal
Cable Length (approx.):
0.94m (from connector to clip's tip)
Weight (approx.): 460 g
Additional Error: The additional error is
negligible when compared to the instrument's
accuracy.
Description P/N Qty.
Operation and Service Manual 16089-90000 1
Description: This test fixture makes it possible to
measure odd-shaped components that cannot be
measured with conventional fixtures. It is equipped with
four alligator clips.
Applicable Instruments: 4263B, 4268A, 4279A, 4284A,
4285A, 4288A, 4294A, (4192A, 4194A, 4263A, 4278A)*
* denotes the instrument is obsolete.
Frequency: 5 Hz to 100 kHz
Maximum Voltage: ±42 V peak max (AC+DC)
Operating Temperature: 0°C to 55°C
DUT Size: diameter of DUT's leads
≤
5 mm
Furnished Accessories:
Compensation and Measurement: Open and short
compensations are recommended before measurement.
For open compensation, do not connect the alligator clips
to anything. Short compensation is performed by holding
a shorting plate with the alligator clips. Make sure that
the alligator clips with the "V" markers are next to each
other. After performing open and short compensations,
the DUT is held with the alligator clips. Connect the same
color test clips to the same terminal of the DUT and have
the clips with "V" markers be closer to the DUT.
Description P/N Qty.
Operation and Service Manual 16089-90000 1
DUT Dimensions