Atec Agilent-16047A - Manual (Page 26)

DUT Size:
Three types of contact boards are provided for the 16043A/B and the contact boards are selected accord-
ingly to the DUT size and electrodes’ separation. The electrode spacings on the contact boards are shown
in the figure above. The 16043A’s contact boards are provided with three groups of electrodes (as shown
in the figure above) and the sliding mechanism allows the DUT to slide down to the next group of elec-
trode. In order to lay the DUT at an appropriate position on the contact board, a device guide fabricated
to fit the size of the DUT is required.
Select the contact boards, that accommodates the DUT size best.
The table to the left shows the applicable DUT sizes for each
contact board.
Furnished Accessories:
Options*:
16043A/B-001: Add Contact Board No.1 P/N 16043-66501 (16043A)/16043-66511 (16043B)
16043A/B-002: Add Contact Board No.2 P/N 16043-66502 (16043A)/16043-66512 (16043B)
16043A/B-003: Add Contact Board No.3 P/N 16043-66503 (16043A)/16043-66513 (16043B)
16043A/B-004: Add Additional Device Guide P/N 16043-00601
*At least one option (16043A/B-001/002/003) must be ordered for 16043A or 16043B.
To maintain the measurement precision, it is recommended to clean the contact boards approximately
every 1,000 times. It is recommended to replace the contact boards approximately every 10,000 times.
21
Up to 110 MHz (4-Terminal Pair) SMD
Description P/N Qty.
Support Angle for the 4294A 16043-01203 1
Device Guide 16043-00601 3
Screws for the Device Guide 0515-2791 2
Guide Pin 16043-24004 2
Support Angle 16043-01212 1
Tweezer 8710-2081 1
Positioning Tool (16043B only) 16043-00607 1
Carrying Case 16043-60150/60250 1
Operation and Service Manual 16043-90000 1
Contact Board
Applicable
DUT Size
No.1
8.1 mm
×
4.5 mm to
3.7 mm
×
3.1 mm
No.2
3.7 mm × 3.1 mm to
2.5 mm
×
2.0 mm
No.3
2.5 mm
×
2.0 mm to
2.0 mm
×
1.2 mm
Electrode configuration for 16043A/B contact board