Atec Agilent-16047A - Manual (Page 77)

16339A Component Test Fixture
Terminal Connector:
* Interlock Connector enables and disables
the application of source voltage from the
measurement instrument.
DUT Connection: 2-Terminal (with triaxial cable)
Dimensions (approx.): 200(W) x 140(H) x 230 (D) [mm]
Cable Length (approx.): 0.8 m
Weight (approx.): 2200 g
72
DC (High resistance) SMD & Lead Components
Description: The 16339A is designed to operate specifi-
cally with 4339B. It is provided with three component
modules, which are used to hold SMD, lead and various
type of devices. Electrical noise effects are reduced by the
employment of a shielded case. A built-in interlocking cir-
cuit enables safe high-voltage measurements.
Applicable Instruments: 4339B, (4339A)*
* denotes the instrument is obsolete.
Frequency: DC
Maximum Voltage: 1000 V
Maximum Current: 10 mA
Resistance Measurement Range: 1 x 10
3 to 2 x 10 16 Ω
Operating Temperature: 0°C to 55°C
DUT Size: For Alligator Clip and Flat Table, lead diame-
ter
≤
5 mm
Furnished Accessories:
Compensation and Measurement: Open compensation
is recommended before measurement. When using the
axial lead module, have no DUT connected to the elec-
trodes. When using the SMD module, separate the high
and low electrodes from each other. The separation
should be equivalent in size to the DUT’s width. When
using the alligator clip and flat table, remove the alligator
clips from the input terminals of the test fixture. After
preparing the open condition of the respective module,
close the top cover and then perform open compensation.
Finally, the DUT is inserted into the respective module.
The following figure shows the three component modules.
Type Connector
Input Triaxial (special screw-type)
Output High Voltage BNC (special type)
Control Interlock connector*
4339B with 16339A
SMD module
Description P/N Qty.
Axial Lead Module 16339-60102 1
SMD Module 16339-60101 1
Flat Table 16339-60004 1
Miniature Banana-Plug cable 16339-61621 2
100 k
Ω
Output Resistor 16339-61001 1
1 M
Ω
Output Resistor 16339-61002 1
10 M
Ω
Output Resistor 16339-61003 1
100 M
Ω
Output Resistor 16339-61004 1
Alligator Clip 8710-1984 2
Carrying Case 16339-60001 1
Operation and Service Manual 16339-90010 1
Component module configurations
SMD module Axial Lead module Alligator clip and Flat table
DUT Dimensions