Using the configuration pages – Extron Electronics MGP Pro Series User Guide User Manual
Page 93
MGP Pro Series • HTML Configuration and Control
87
Using the Configuration Pages
There are three Configuration pages, which only administrators can access. When you
click the
Configuration
tab, these pages are listed on the sidebar menu at the left of the
screen. The following sections describe the changes you can make from these pages.
System Settings Page
On the System Settings page (figure 31), you can set IP parameters for the MGP Pro.
1
Figure 31.
System Settings Page
To change your system settings:
1.
On the
Configuration
tab, select
System
Settings
from the sidebar menu at the left
edge of the screen.
2.
Select or enter the new information in the desired fields.
3.
When you have made all the desired inputs, click the
Submit
button at the bottom of
the section.
IP Settings fields
The IP Settings fields provide a location for viewing and editing settings unique to the
Ethernet interface. After editing any of the settings on this page, click the
Submit
button at
the bottom of the IP Settings section.
Unit Name field
The
Unit
Name
field contains the name of the MGP Pro. The name assigned at the factory
consists of the model name, followed by the last three character pairs of the
You can change this name field to any valid name, up to 24 alphanumeric characters.
NOTE: The following characters are invalid in the name:
+ ~ , @ = ` [ ] { } < > ' " ; : | \
and
?.