Extron Electronics MGP Pro Series User Guide - Manual (Page 21)

MGP Pro Series • Operation 15
Power-up and Default Cycle
When you first plug the MGP Pro into a power source, the LCD screen displays an initial
screen, which contains the product name, model, and firmware version. This is followed by
the default cycle of screens showing the current input type for each window and the output
resolution and refresh rate. These messages continue to cycle on the LCD screen when
the menu system is not in use. The following flow diagram shows the order in which these
screens appear.
Figure 13. Default Cycle Example
NOTE: From any menu or submenu, the MGP Pro saves all adjustment settings and
times out to the default screens after 20 seconds of inactivity.
Window Select Buttons
The MGP Pro front panel contains two (MGP 462 Pro) or four (MGP 464 Pro) Window
Select buttons. Use these buttons in conjunction with the Input buttons to specify which
window displays an input, or use them with the picture control buttons to specify which
window or image will be adjusted.
When you select a picture control, the window whose button was previously selected is
affected (see
Picture Controls on page 34 for information on the available controls.)
To select a window, press its Window Select button, which lights. To deselect a window,
press any other Window Select button.